Morel SOUNDSPOT ST-95 - Manual (Page 17)

7. VOLTAGE SELECTOR switch
Before operating, adjust the position of the voltage selector
switch to 115V or 230V, according to the power supply in your
country.
8. AC outlet
Power supplied through this outlet is turned on and off by the
POWER switch.
Before making connections it is advisable to
ensure that all AC power cords of the components
you are interconnecting are unplugged from the
wall outlets during the hookup process.
Connection Guidelines
Connection Through the Line-Level (RCA) Inputs
Use this connection option if your amplifier has a low frequency exit
(LFE) subwoofer output, or pre-amp outputs (all AC3 or Dolby
Surround amplifiers have such an output). Connect the two LFE (or
PRE OUT) outputs (for left and right channels), to the two LINE IN
inputs in your SoundSub
TM
, using an RCA (interconnect) cable pair.
If your amplifier has only a single subwoofer output, then connect
this output from your amplifier to just one of the LINE IN inputs
in your SoundSub
TM
.
Connection Through the High-Level (BINDING POST) Inputs
Use this connection option if your amplifier does not have an
LFE output (this is the case, for instance, if you are using a
Prologic or hi-fi amplifier). Using a speaker cable: connect the
red or (+) right speaker output terminal of your amplifier to the
R+ terminal on your subwoofer, and connect the black or (- )right
speaker output terminal on the amplifier to the R- terminal on
the subwoofer. Repeat the process for the left speaker,
connecting the red or (+) left speaker output terminal