MITSUBISHI ELECTRIC DD-6050 - Manual (Page 13)

– 13 – EN
1L25
CONNECTING TO AN AMPLIFIER EQUIPPED WITH DIGITAL
INPUT JACKS SUCH AS MD DECK OR DAT DECK
Use an audio coaxial or optical digital cable (not included) for the audio connections.
Connecting to an amplifier equipped with digital input jacks such as MD Deck or DAT Deck:
AUDIO OUT
COAXIAL R
L Y
S-VIDEO
OUT
COMPONENT
VIDEO OUT
CR/PR
DIGITAL AUDIO OUT
VIDEO OUT CB/PB
To COAXIAL DIGITAL AUDIO INPUT jack
Amplifier equipped with digital
input jacks, MD deck,
DAT deck, etc.
To VIDEO
INPUT jack To VIDEO OUT jack
or
To S-VIDEO INPUT jack
To S-VIDEO OUT jack
To COAXIAL DIGITAL
AUDIO OUT jack
[Fig. 6]
Notes
¡ The audio source on a disc in a 5.1 channel Dolby Digital surround format cannot be recorded as digital sound
by an MD or DAT deck.
¡ Be sure to turn off the power to all components in the system before connecting another component.
¡ Refer to the Owner’s Manuals for the components to be connected to the DVD player.
¡ Set "DOLBY DIGITAL" and "DTS" to "OFF" for audio output in the setup mode. Playing a DVD using
incorrect settings may generate noise distortion, and may also damage the speakers (See page 32 to set "ON"
for "DOLBY DIGITAL" and "DTS").
HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS
If your TV does not have RCA type audio and video input jacks, it is still possible to connect this DVD
player to your TV’s 75-ohm coaxial antenna terminal using a commercially available Stereo Audio/Video
RF Modulator that is not included. Connect the audio and video outputs of the DVD player to the audio and
video inputs on the RF Modulator, and then connect the coaxial output of the RF Modulator (usually marked
“TO TV”) to the 75-ohm coaxial antenna terminal on your TV. Follow the instruction supplied with the RF
Modulator for more details.
If your TV’s 75-ohm coaxial antenna terminal is already occupied by an antenna or cable box connection,
remove that cable from your TV’s antenna terminal and reconnect it to the coaxial antenna input terminal
of the RF Modulator (usually marked “ANT IN”), then connect the RF modulator to your TV’s antenna
terminal as described above.
Note
¡ The picture quality from DVD discs will not be as good if the DVD player is connected to the TV’s
antenna terminal through an RF Modulator.
E5931UD_2çZ.qxp 04.2.25 6:00 PM Page 13