Master Lock ATS 211 - Manual (Page 5)

5
Straight
Door Arm
Door Bracket Plate
Door Bracket
Safety Labels
and
Literature
"C" Wrap (2)
Safety Reversing Sensor
Mounting Bracket
With Slot (2)
2 -Conductor Bell Wire
White & White/Red
Curved Door Arm
2 -Conductor Bell Wire
with Connector (2 rolls)
White & White/Black
Rail
Styrofoam
Chain
Pulley Bracket
Trolley
Chain
Safety Reversing Sensor
Mounting Bracket
With Square Holes (2)
Lighted Door
Control Button
Mounting Hardware
(Rail Support Bracket)
Rail Support
Bracket
Header Bracket with
Clevis Pin and Fastener
UP
CEILING MOUNT ONLY
Safety Reversing Sensor (2)
(1) Sending Eye - (1) Receiving Eye
Opener Carton Inventory
Your garage door opener is packaged in two cartons which contain all parts illustrated below. If anything is missing,
carefully check the packing material. Parts may be "stuck" in the foam. Hardware for assembly and installation is
listed below.
Assembly Hardware
5/16"-18x1/2" Washered Screw, (2)
(Mounted in Opener)
1/4"-20x5/8" Hex Screw (2)
1/4"-20x5/8" Lock Washer (2)
#8-32x3/8" Screw (1)
5/16"-18x1/2" Washered Screw (2)
Installation Hardware
Hex Screw 5/16"-18x7/8" (4)
Nut 5/16"-18 (6)
Lock Washer 5/16" (6)
Rail Grease
Lag Screw 5/16"-18x1-7/8" (4)
Screw 6ABx1-1/2" (2)
Handle
Ring Fastener (3)
Carriage Bolt 5/16"-18x2-1/2" (2)
Insulated Staples (10)
Dry Wall Anchors (2)
Clevis Pin 5/16"x2-3/4" (1)
Clevis Pin 5/16"x1" (2)
Rope
Hardware for Safety
Reversing Sensor
Lag Screw 1/4x1-1/2" (4)
Carriage Bolt 1/4"-20x1/2" (4)
Lock Nut 1/4"-20 (4)
Wing Nut (2)
Hex Screw 1/4-20x1-1/2" (2)
Screw #10-32x3/8" (4)
Lock Nut #10x32 (4)
Insulated Staples (20)
Hardware Inventory