Metra Electronics 95-7801 - Manual (Page 10)

95-7801 DASH DISASSEMBLY
HONDA PRELUDE 1992-1996
8
1 Disconnect the negative battery terminal
to prevent an accidental short circuit.
Remove (2) screws from the top of the con-
sole trim bezel. Slide the front seats back
and remove (4) Phillips screws from each
side of the bezel. Pull up on the console
trim bezel and remove. Using an angled
screwdriver, remove (2) screws securing
the gear shifter bracket to the bezel.
Remove (4) screws from the radio trim
bezel, remove the factory head unit assem-
bly and disconnect the wiring. (Fig. A) 2
3
HONDA PRELUDE 1997-2001
1 Disconnect the negative battery terminal
to prevent an accidental short circuit.
Using a panel removal tool, unclip the radio
trim bezel and remove (some force may be
required). Remove (4) Phillips screws
securing the factory head unit/bracket
housing assembly and disconnect the
wiring. Remove (4) Phillips screws secur-
ing the factory head unit to the bracket
housing and remove. (Fig. A) 2
3
A
2
"F"
"F"
Fig. B
Fig. C
"H"
"H"
B
A
"A"
"A"
"G"
"G"
B
Cut and remove all mounting clips on the
Radio Housing EXCEPT clips "A" and
"G". (Fig. B) Skip to step #3a on Page 9.
Cut and remove the mounting tabs from
the bottom of the Rear Support Tray (Fig.
B). Cut and remove all mounting clips on
the Radio Housing EXCEPT clips “F” and
"H" (Fig. B). Cut and remove the slots on
the bottom of the ISO Brackets (Fig. C).
Skip to step #3b on Page 10.