Metra Electronics 95-7801 - Manual (Page 4)

95-7801 DASH DISASSEMBLY
ACURA INTEGRA 1994-2001
2
Remove the cover cap located under the emer-
gency brake and remove (2) screws exposed.
Remove (2) screws from the rear corners of the
lower dash trim bezel and remove. Remove the
ashtray and (2) screws exposed. Unsnap the
ashtray housing and disconnect the cigarette
lighter harness. Remove the gear shifter knob
and unsnap the shifter trim. Remove (2) screws
below the radio opening and remove the upper
dash trim bezel. Remove (2) 8mm screws secur-
ing the factory head unit and disconnect the
wiring. (Fig. A) 2
ACURA LEGEND 1990-1996
Remove (2) screws below the ashtray.
Unclip the dash trim bezel. Disconnect the
cigarette lighter wiring and remove the
bezel. Remove (2) bolts securing the rear
of the factory head unit and disconnect the
wiring. (Fig. A) 2
A
2
"C"
"C"
Fig. A
Fig. B
"H"
"H"
B
A
"E"
"E"
"J"
"J"
Fig. A
Fig. B
B
1 Disconnect the negative battery terminal to pre-
vent an accidental short circuit.
1 Disconnect the negative battery terminal to pre-
vent an accidental short circuit.
3 Cut and remove all mounting clips on the Radio
Housing EXCEPT clips "C" and "H" (Fig. A). Cut
and remove the slots on the bottom of the ISO
Brackets (Fig. B). (THE REAR SUPPORT TRAY
WILL NOT BE USED). (Fig. B)
Skip to step #3b on Page 10.
3 Attach the Mounting Bracket to the bottom of
the Rear Support Tray (Fig. A). Cut and remove
all mounting clips on the Radio Housing
EXCEPT clips "E" and "J". (Fig. B)
Skip to step #3b on Page 10.