Marathon RJ-100SC - Manual (Page 30)

REVIEW THIS MANUAL BEFORE MAKING THE INSTALLATION. STUDY THE JOB-
SITE AND INSTALLATION REQUIREMENTS CAREFULLY TO BE CERTAIN ALL
NECESSARY SAFEGUARDS AND OR SAFETY DEVICES ARE PROVIDED TO
PROTECT ALL PERSONNEL AND EQUIPMENT DURING THE INSTALLATION AND
AS A COMPLETED SYSTEM. SPECIAL ATTENTION IS DIRECTED TO THE
EXTRACT FROM AMERICAN NATIONAL STANDARDS INSTlTUTE Z245.2 .
These operating instructions are not intended as a substitute for training and experi-
ence in proper use and safety procedures in operating this equipment.
Marathon Equipment Co. does not assume responsibility for the installation pro-
cedures of this equipment. Conformance to applicable local, state, and federal
laws concerning installation rests with the customer.
Preferred dimensions of the concrete pad are 10'0" wide and a length of 5'0" greater
than the length of the compactor/container. It should be level and of minimum 3000
PSI concrete steel reinforced, 6" thick. It is preferred that the concrete pad be flush
with the surrounding ground level. NOTE: Units with four ground rollers must be
installed on a level pad.
To provide accessibility, concrete pad should be positioned to allow 2'0" between
machine and building wall if installed parallel with building. Allow a minimum of 45'
of clear space from end of pad for container handling vehicle.
Note: The clearances given are minimums. Your installation may require greater
clearances depending on the site and the hauling equipment that will be used.
3 INSTALLATION
CONCRETE PAD REQUIREMENTS 3-1
CAUTION:
CONCRETE PAD
1.
2.
If container guides (optional) are used with the self-contained units, the guides should
be anchored to the concrete pad using 3/4" X 6" anchor bolts. These bolts should be
concrete anchors or expansion type anchor bolts. To allow for construction variations, it
is best if these holes are drilled in the concrete after prelocating the container guides in
their desired location. Drill holes and place anchor bolts in each location provided on
the guides. When the guides have been placed in position, and the anchor bolts have
set, tighten all nuts securely.
CONTAINER GUIDES