Marathon RJ-100SC - Manual (Page 35)

4 HAULER INFORMATION
HAULER INSTRUCTIONS - GENERAL 4-1
Before hauling to the landfill:
Disconnect all hoses and electrical connections (if applicable) between the power
unit and the compactor. Make sure they are laid in an area where they will not get
damaged.
Close and secure any hopper doors or gates.
Make sure that the container door safety chain is secured in the keyhole on the
latch side of the container floor.
If the unit is a Streamline model (SL), disconnect any drain hose(s) connected to
the unit and plug all ports.
Make sure that the hoist lifting the unit is compatible with the understructure
on the unit.
NOTE: Hold-downs should be used to secure the front and rear of the of the
container understructure to the hoist.
1.
2.
3.
4.
5.
After returning from the landfill:
After setting the unit down, reconnect all hoses and electrical connections (if applic-
able) to the compactor. Make sure they are not laying across sharp corners or any
abrasive surface.
Close and secure any hopper doors or gates.
Make sure that the container door safety chain is secured in the keyhole on the
latch side of the container floor.
If the unit is a Streamline model (SL), connect any drain hose(s) to the unit.
1.
2.
3.
4.
At the landfill:
SEE THE NEXT PAGE FOR DOOR AND LATCH OPERATION INSTRUCTIONS.
To prevent leakage, the door seal and mating surface should be wiped clean and
inspected after the unit has been emptied. When cleaning the seal on units with the
hydraulic tailgate option,
WARNING: NEVER place any part of your body between the tailgate and the
container. Use a mop or similar cleaning device with a long handle to clean
the seal. Close inspection of the seal should be done only after the container
has been lowered to a level position and the raised tailgate has been support-
ed with a crane, forklift, or other positive maintenance prop.
Replace the seal if damaged.
1.