Middleby Marshall PS624E - Manual (Page 11)

SECTION 2
INSTALLATION
7
WARNING
Do not obstruct the flow of combustion and ventilation air to and from your oven. There must be no
obstructions around or underneath the oven. Constructional changes to the area where the oven is
installed shall not affect the air supply to the oven.
CAUTION
For additional installation information, contact your local Authorized Service Agent.
NOTE
There must be adequate clearance between the oven and combustible construction. Clearance
must also be provided for servicing and for proper operation.
NOTE
An electrical wiring diagram for the oven is located inside the machinery compartment.
WARNING
The oven must be installed on an even (level) non-flammable flooring and any adjacent walls must
be non-flammable. Recommended minimum clearances are specified in the Description section of
this Manual.
NOTE - AUSTRALIA INSTALLATION
In Australia, the oven installation must conform with any requirements of the appropriate statutory authority.
NOTE - CANADA INSTALLATION
In Canada, the oven installation must conform with local codes. Installed ovens must be electrically
grounded in accordance with local codes, or in the absence of local codes, with the Canadian Electrical Code
CSA C22.2.
NOTE
In the USA, the oven installation must conform with local codes. Installed ovens must be electrically
grounded in accordance with local codes, or in the absence of local codes,
with the National Electrical Code (NEC), or ANSI/NFPA70.
NOTE
All aspects of the oven installation, including placement, utility connections, and ventilation requirements,
must conform with any applicable local, national, or international codes. These codes supersede the
requirements and guidelines provided in this manual.
NOTE - CE OVEN INSTALLATION
Four casters are provided to allow the oven to be more easily moved to the installation location. These casters
are intended to simplify pre-installation movement only, and are NOT suitable for use as part of a CE oven
installation. During the installation procedure, the casters MUST be removed, so that the oven can be
supported by the supplied 152mm adjustable legs.
NOTE - GROUNDING INSTRUCTIONS
The oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wirdor electric current. This product is equiped with a cord having a grounding wire
and an appropriate grounding plug. This plug must be plugged into a properly installed outlet in accordance with all
local codes and ordinances.
WARNING: Improper installation of the grounding plug can result in the risk of electric shock. The grounding wire
has insulation with an outer surface that is green with or without yellow stripes.
Implementation of the grounding requirements should be carried out by a qualified electrician or service techni-
cian. Do not modify the appliance plug provided. If the appliance plug does not fit the outlet, the outlet should be
replaced by a qualified electrician.
SECTION 2
INSTALLATION