Memorex MPH4385 - Manual (Page 15)

E–13
RESET SWITCH:
The RESET switch is located at the bottom of the unit. If the telephone locks up or
does not work properly, it must be reset, but the call and program memory will be lost.
Make sure to program in the local area
code before auto dialing (see page 6).
Select the number using the UP and
DOWN buttons ❶. If the telephone
number displayed is a 7 or 10 digit
number, simply press the DIAL button ❷
and the number will automatically be
dialed (“1” will be dialed before the area
code for ones that require it).
1
1
2
1
If you want to add the “1” before the area
code, press and hold the DIAL button for
2 seconds and the 10 digit number will
be dialed with the “1”.
2
TO AUTOMATICALLY DIAL A NUMBER IN THE CALLER ID DISPLAY (OFF HOOK)
CALLER ID OPERATION
Care and Maintenance
1. Clean your phone with a damp (never wet) cloth. Solvent or detergent should
never be used.
2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
3. Keep your unit away from heating appliances.
CALL WAITING
When a call is received when you are
using the phone, and have the call
waiting feature enabled through your
telephone company, a beep will sound
and the caller ID display will show the
name and number of the incoming caller.
Press the FLASH button to switch over
to the new call.
This feature must be activated through
your local telephone company.
MPH-4385 (REVISED2/01).O/M.QXD 6/20/01 7:41 AM Page 14