Installation, Installing the hardware, Installing the software – Michelin Navigation User Manual
Page 7: Nstalling the hardware, Nstalling the software
2. Installation
2.1. Installing the hardware
•
Installing on the
windscreen
:
install the car mounting system on the windscreen by
applying pressure to the suction pad and then turning the screw clockwise (reverse the
procedure to remove the windscreen mounting system).
•
Installing on the
dashboard
:
remove the protective film from the plate, position it on a
perfectly smooth and clean surface by pressing evenly over the whole area, then install
the mounting system as described above.
•
Mount your ViaMichelin Navigation X-930 on the mounting system by sliding it in as
shown (see the installation diagram provided).
•
Start your vehicle.
•
Connect the cigarette lighter cable to your ViaMichelin Navigation X-930 (by plugging
the cable into the mini-USB port under the device) then into your vehicle’s cigarette
lighter socket.
2.2. Installing the software
ViaMichelin Navigation is a “Plug & Drive” solution: Simply insert the memory card
provided into the slot on the top of your PND (Personal Navigation Device) then follow the
installation instructions displayed on your screen: rights, choice of the interface language,
voice guidance language, 2D or 3D map display, etc.
ViaMichelin Navigation is now ready to guide you!
Comments:
• Make sure that your SD is not in the “Lock” position, as this may prevent ViaMichelin
Navigation functioning properly (“Lock” position protects the contents of your SD card, but
this also prevents the ViaMichelin programs from saving the information required for the
software to run properly).
• Make sure the X-930 is also not in the "Lock" position.
The button on the right of the SD
card slot must be positioned with the "padlock logo" open.
• Do not delete any of the data stored on your ViaMichelin Navigation SD card.
• Do not add any further data to your ViaMichelin Navigation SD card.
• Do not insert your SD card into another PDA or PND: this may damage its contents.
Detailed instructions for installing the DVD-ROM are given in Chapter 7 of this manual.
3