Philips Magnavox 20MDRF20 - Manual (Page 11)

First-Time Setup, Watching TV 11
These SET UP screens will appear the first time you turn on
the TV/DVD. Set the language for the menus and have the
unit memorize available TV channels.
If you are using a Cable Box or Satellite Receiver, do not set
channels at the TV/DVD. Set it to the output channel of the
Cable Box/Satellite Receiver (channel 3, 4, or AUX). Select
channels at the Cable Box/Satellite Receiver. See page eight.
1 Press STANDBY-ON to turn on the TV/DVD.
2 Press ENTER repeatedly to select ENGLISH,
ESPAÑOL, or FRANÇAIS. The selected language
will appear inside the [ ]. This will be the language of
the TV/DVD menus.
3 Press ▲ or ▼ to select AUTO PRESET. Then
press ENTER. The menu will disappear and the
TV/DVD will start scanning channels. Active channels
will be memorized during this process.
When scanning is complete, the TV/DVD will go to
the lowest available channel automatically.
4 To watch TV, press the CH. ▲ or ▼ buttons to
select memorized channels. These appear automatical-
ly when you flip through channels. If a channel is
skipped, use the Number buttons to select it. This is a
non-memorized channel; it may have weak reception
in your area.
Remember, if you are using a Cable Box/Satellite
Receiver, set the TV/DVD to channel 3 or 4 or AUX.
Change channels at the Cable Box/Satellite Receiver.
5 Press VOL. ▲ or ▼ to adjust the volume.
• If the power fails, you may need
to repeat this first-time setup.
• You may not see these menus
when you turn on the TV/DVD.
Set channels and the menu lan-
guage later. See page 17.
• To select Cable TV channels
above 99, press the + 100/+10
button, then press the Number
buttons for the last two digits.
For example, to select channel
125, press +100/+10, 2, 5.
Precede single-digit channel num-
bers with a zero (for example,
0
1 ... 09).
• Pressing CH. ▲ or ▼ in DVD
mode puts the unit in TV mode.
• If you turn off the unit in DVD
mode, when you turn it on again,
it will be in TV mode.
• To remove the SET UP menu or
stop scanning channels, press
SETUP on the remote.
2-3
1
4
5
Helpful Hints
– SET UP –
LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET
B
– SET UP –
LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET B
VOLUME 20