Philips Magnavox 20MDRF20 - Manual (Page 23)

Setting V-Chip (cont’d) 23
• If you enter the wrong code in the
CONFIRM CODE space, repeat
step 5. Enter the same new code
exactly in the CONFIRM CODE
space.
• If the power fails, the default code
will be active again (0000).
Change your access code again as
necessary.
Helpful Hints
Changing the Access Code
Although the default code 0000 is supplied with the TV/DVD,
you can set your own access code.
● Before you begin, press SELECT to put the
TV/DVD in TV mode.
1 Press SETUP.
2 Press ▲ or ▼ to select V-CHIP SET UP.
Then, press ENTER.
3 Press the Number buttons to enter the old
access code. When doing this for the first time, use
0000.
4 Press ▲ or ▼ to select CHANGE CODE.
Then, press ENTER.
5 Press the Number buttons to enter your
desired access code in the NEW CODE space.
Then, enter the same code in the CONFIRM
CODE space. The V-CHIP SET UP screen will
reappear.
(Four Xs will appear on the screen instead of your
code. This protects the code’s identity. Your code
must have exactly four digits.)
6 Press SETUP to save your settings and remove the
menus.
PREV NEXT
OPEN/CLOSE
2,4
3,5
1,6
ACCESS CODE
– – – –
– V-CHIP SET UP –
TV RATING
MPAA RATING
CHANGE CODE
B
NEW CODE
CONFIRM CODE
X X X X