910 in st al la ti o n in st al la ti o n – Motorola ME4050 User Manual

Page 6

Advertising
background image

9

10

In

st

al

la

ti

o

n

In

st

al

la

ti

o

n

Open the battery compartment by pushing downwards
on the battery compartment cover. Insert AAA-type

batteries, observing the correct polarity.

Inserting the Batteries

The mobile handset will not operate if the batteries

are inserted incorrectly. There is also a possibility

that the handset may be damaged thereby.

Insert the plug of the mains adaptor in the

socket on the underneath of the charger unit.
Plug the mains adaptor into the mains socket.
The charger unit is now ready to use.

Connecting the Charger Unit

The base station does not
have a power switch. Make
sure that there is a mains
socket nearby and that the
mains adaptor is easily
accessible. Check that the
voltage indicated on the
mains adaptor corresponds
to that of your mains
current.

Insert the plug in the corresponding socket of the base station (it is not possible to
mix them up as the socket and plug are designed to be reverse-polarity protected).
Route the cable beneath the telephone towards the back. Insert the plug into the
socket of the telephone plug of your telephone connection. Insert the mains adaptor
in the wall socket. The base station is now ready for use.

Do not expose the base station and charger unit to direct sunlight. Do
not allow the base station and charger unit to become wet. They should
not be set up in rooms which are subject to condensation or corrosive
steam or a high concentration of dust (e.g. cellars, garages or
conservatories). The room temperature must be between 0

0

C and 35

0

C.

Connecting the Base Station and Mains Adaptor

Replace the cover on the battery compartment and push it upwards

until it clicks into place. Place the handset in the base station.

A confirmation beep and the charging indicator confirm that charging has begun.

Note: When used for the first time, allow the batteries to charge for at least 14 hours

without interruption. If possible, only take the handset out of the base station when
the charging process has ended. This will help to guarantee optimum operation.
Note: To ensure the battery charging properly, clean the charging contacts on the

handset and charger with a soft, dry cloth once a month. Clean more often if the unit is

subject to grease, dust or high humidity.

Advertising