MITSUBISHI ELECTRIC MC300 Workstation Computer - Manual (Page 19)

15 MAN-WKSTN-001 MC Series Computers
5 EXTERNAL COMPONENTS
Parallel Port Connector
Parallel Port Connector (LPT1) is used to connect to a printer.
Serial Port Connectors
The serial ports are 9-pin D-Sub male connectors. COM1 is a dedicated RS-
232 port. COM2 is a RS-232/RS-422/RS-485 selectable port.
One KEYBOARD Connector
A personal system/2 (PS/2)–style keyboard port
Expansion Card Slots
PCI Slot 1, PCI Slot 2, PCI Slot 3
The Workstation will support the addition of three 32-bit PCI (Periph-
eral Component Interconnect) Cards if you want to upgrade your
system.
CPU Board Slot 4
This slot is used by the CPU board. Tthere are 3 connectors on this board,
they are:
One MOUSE Connector
A personal system/2 (PS/2)–compatible mouse port
10/100 ETHERNET
This is an RJ-45 connector. 10/100–megabit-per-second (Mbps)
network interface controller (NIC) provides all the functions of a
separate network card with Wakeup on LAN technology. The NIC
supports both the 10BASE-T and 100BASE-TX Ethernet standards.
Video Connector
A 15-pin D-sub female connector for attaching an external monitor to
the Panel Computer. SVGA for 12" Models and XGA for 15" Models.
PICMG or ISA Slot 5
This slot will support the addition of one PICMG (PCI Industrial Computer Manu-
facturers Group) Card or one ISA Card.
ISA Slot 6, ISA Slot 7
The Workstation Computer will support the addition of two ISA (Industry-Stan-
dard Architecture) Cards if you want to upgrade your system.