MACKIE HDR 24/96 - Manual (Page 36)

HD24/96 Technical Reference 36
will be stored. If you press STORE a second time without storing a LOC time,
the Store operation is cancelled.
Looping (LOC 1 and LOC 2)
Loop is a tool to repeat playback or recording from one point in time (Loop Start) to
another (Loop End). The LOOP button toggles the loop function.
With Loop mode enabled, if the current time position is outside the loop region, when
you press Play, the transport will jump to the Loop Start time and begin playing until the
Loop End time is reached. The transport will then instantly rewind and begin playing
again from the loop start point. It will continue to cycle between the loop points until you
take it out of either Play or Loop.
NOTE: If the current time is between the loop points when the transport is started, it
begins playing from the current time until the loop end point is reached, and then will
begin cycling between the two loop points.
While it makes sense to have LOC 1 earlier than LOC 2, it doesn’t matter as far as
looping is concerned. The transport will loop from the earlier point to the later one.
Loop Selection
Loop Selection provides the ability to loop-play a selected area of a Playlist. Since this is
a Playlist-specific function, it’s available only from the GUI.
Use the I-Beam tool to select the area over which you want to loop. Select Loop
Selection from the Transport pull-down menu or from the pop-up menu which appears
when right-clicking in the Time Bar or Marker Bar area above the “tracks” display. The
loop area will be highlighted with a yellow bar.
When playback is started, the transport will locate to the beginning of the selected area,
play through to the end of the selected area, and then repeat until the transport is
stopped. You can adjust the end points of the looped selection by dragging the edges of
the selected area using the I-Beam Tool. Adjustment can be made while the transport is
running or stopped.
NOTE: If you want those loop selection points to stick around for a while, you’ll have to
copy them into the LOC 1 and LOC 2 time fields. Drag the Current Time bar to the loop
start point, hold down the Ctrl key and click in the LOC 1 time field to copy the time into
LOC 1. Do the same for the end point and LOC 2.
IMPORTANT: If you’re using SMPTE or MIDI time code output from the HDR24/96 to
synchronize another device, be aware that what you see is what you get. When looping,
the time code cycles and follows the loop. A short loop might drive a synchronized
recorder bananas. Some devices, notably sequencers, send continuously advancing
time code even when they’re looping.
Auto Punch (LOC 3 and LOC 4)
Punch is an automatic recording feature that switches a record-armed track (or tracks)
into Record mode at a specified punch-in point, and takes it out of Record at the
specified punch-out point. See Auto Punch on page 40 for details.
AutoPlay mode
AutoPlay is a step-saving tool that automatically starts Playback when you’ve jumped to a
LOC or Cue point. You might find it handy when using Auto Take. Set a LOC or Cue at a