Moffat MDB900 - Manual (Page 35)

35
• Twist the bared wires using pliers.
• Cut bared wires 10mm away from the end of
the inner insulation. Where un-insulated
Earth wires are used ensure they are
suitably sheathed to leave 10mm bare wire
to fit into the terminal.
• Clamp bare wires into the relevant terminal
and check they are held by tugging each one
in turn.
• Clamp the mains cable securely ensuring
5mm of the outer insulation is inside the
terminal block and that the wires are not
taught but not so slack as to cause any
fouling.
• Place fuse/miniature circuit breaker in circuit
and switch on at mains.
Checking electrical connections
Correct electrical connection can be confirmed
when switching on the appliance, as the timer
will be flashing.
IMPORTANT!
House circuit
Earth leakage and continuity tests must be
carried out before the appliance is connected to
the mains supply and re-checked after fitting.
Connecting to a hob or cooker
point
• Either follow in general terms the instructions
for connecting to the terminal block or refer
to the hob suppliers installation instructions.
WARNING!
Feed the cable through the cabinet and
arrange to route the cable away from the
appliance which may become hot.
Fitting into the cabinet
IMPORTANT!
Ensure that the oven is switched off at the wall
before any further work is carried out.
• Using a tape measure establish the internal
width of the cabinet. Refer to recommended
cabinet dimensions if greater than 565mm.
• Position the appliance in front of the cabinet.
• Take out all oven furniture before installation
to reduce the weight you need to lift. The
oven door should be taped up to keep it
closed whilst lifting.
• To place the appliance into the cabinetry
follow the procedure below: