Motorola BASIC XTS 3000 - Manual (Page 27)

Common Radio Features
23
Turning Scan On and Off
Place the Scan On/Off Switch (if programmed, see
page 2) in the “scan on” position or the “scan off”
position.
Deleting Nuisance Channels
When the radio scans to a channel that you do not wish to hear (nuisance
channel), you can temporarily delete the channel from the scan list.
1. When the radio is locked onto the channel to be
deleted, press the Nuisance-Delete Button (if
programmed, see page 2). Repeat this step to delete
additional nuisance channels.
Priority channels and the selected channel
cannot be deleted using the nuisance-
delete feature.
2. The radio continues scanning the remaining
channels in the list. To resume scanning the
deleted channel, you can change channels or leave
and re-enter scan operation.
Dynamic Priority Change (Conventional Operation Only)
While the radio is scanning, the dynamic priority change feature lets you
temporarily change any channel in a scan list (except the priority-one
channel) to the priority-two channel. The present priority-two channel
becomes a non-priority channel. This change remains in effect until scan is
turned off, then scanning reverts back to the preprogrammed state.
1. When the radio is locked onto the channel to be designated as priority-
two, press the Dynamic Priority Button (if programmed, see page 2).
The priority-one channel cannot be changed to priority-two.
2. The radio continues scanning the remaining channels in the list. To
resume scanning the preprogrammed priority-two channel, you must
leave and re-enter scan operation.
See page 2
for your
radio’s
feature-
control
programming.
A
B C
See page 2
for your
radio’s
feature-
control
programming.
A B
C Note
Note
Model I Book Page 23 Wednesday, August 14, 1996 8:51 AM