MITSUBISHI ELECTRIC MS540 - Manual (Page 66)

T e c h n i c a l I n f o r m a t i o n
C/1
C SYSTEM BIOS AND SET-UP
When the system is switched on, the POST does its job depending
upon the information it finds in the BIOS and sets up the computer
to boot into operation. You can access the BIOS and check or alter
the configuration via its set-up utility.
Caution
The BIOS has been set in our factory for the optimum system performance and
operation. It is not advisable to alter any settings under normal use.
Entering Set-up
During, or just after, the POST, a small box appears in the top right
corner of the screen.
It looks like this :
While this is on the screen press F1 on the keyboard, and in a few
seconds you will be presented with the BIOS set-up screen.
You cannot enter this set-up utility at any other time or by any other method .
Control keys
F1 Help on the highlighted topic, pressing it a second time
transfers you to the general help pages.
Esc Exit either the set-up, or go back a page if in a sub-menu.
~~~~ ~~~
~~~~ ~~~
~~~~ ~~~