Minuteman UPS XRT Series - Manual (Page 14)

13
INSTALLATION, STEP BY STEP
1. Insure UPS Power switch is OFF. Place the optional XRTBP
battery pack(s), if used, and XRT UPS in its final location.
2. When installing the XRT1000 and above UPS’s or the XRT600
with optional battery pack(s):
a) Remove the self stick protective strip from the rear of the XRT600
(not required on XRT1000 , 1500, and 2000), and from the optional
battery pack cable.
b) Loosen the retainer screws on the rear of the UPS and drop the
retainer bracket down.
c) Plug the battery pack cable connector into the XRT remote battery
pack connector insuring connections mate RED to RED and
BLACK to BLACK. Push the retaining bracket “up” to secure the
battery connector in place and re-tighten the screws.
d) Verify the bracket will not allow removal of the connector. Each
battery pack is “daisy chained” in a similar fashion with the cable
from the last battery pack connected to the previous pack. Remove
the protective strips only from the battery connectors that are
used.
NOTE: When the protective strip is removed from the XRT UPS or the
XRTBP cable connector, battery system voltage (48 VDC) is
present at these connector contacts. Please keep the connector
contacts covered with the protective strip when not mated with
another connector.
Battery Pack Connection Diagram