Marquis Spas - Manual (Page 18)

(continued)
Dura Base ™ External Drain and Fill Valve
1. Remove plug from the external Drain and Fill valve.
2. Attach a hose to the external drain and fill valve
on the DuraBase ™ . A Fill Filter is recommended
when filling. Attach to the end of a garden hose
to filter out any grit and sediment that may
accumulate in the spa and potentially scratch the
spa surface during the process.
3. Open the valve by turning the ring counter-
clockwise. Gravity will cause the water to drain
out of the hose.
4. When the spa is empty, close the valve by
turning the ring clockwise and remove the hose.
5. Replace the plug in the drain and fill valve.
6. Follow step five above to refill your spa.
CLEANING THE SPA AND SAFETY ENERGY COVER
Should the DuraShell ® interior become soiled, it can be cleaned with a soft sponge,
cloth Scumbug Duramitt #6875 or Tub Scrubber #6000. Do not use any abrasive
cleaners as they can scratch or dull the spa surface.
Your Safety Energy Cover can be cleaned with Marquis Spa Care ™ Cover Cleaner on
both top and bottom sides. Marquis Spa Care ™ Cover Cleaner is a good quality NON-
SILICONE based vinyl restorer that will help protect the surface from the sun’s rays.
REMOVING THE FILTER
Refer to the SPA MAINTENANCE SCHEDULE
section for cleaning instructions. Follow these
instructions when performing routine maintenance.
Vortex Filtration:
1. Grasp the edge of the dome-shaped Vortex
filter top, pull up firmly, but gently, to remove it.
2. Use the filter handle and turn the filter
cartridge counterclockwise to unscrew it
from its base.
3. Lift out the filter cartridge.
Maintenance Reminder will show CL every 30 days to
remind you to clean your filter. Use Marquis Spa
Care
™ Filter Revive and Filter Soak Canister. It’s
recommended that you keep a spare filter on hand
for cleaning. Replace your filter once a year. Filters
are available through Marquis Essentials.
REINSTALLING THE FILTER
Repeat the steps above in reverse order to reinstall
the filter. Do not overtighten the filter as it may
cause failure of the filter cartridge. When replacing
the Vortex filter top, center the top over the raised
filter ring, and press down firmly until the top snaps into place.
spa
maintenance
page 17
ᮣ
ᮣ
ᮣ