Middleby Marshall PS528-Series OVENS PS528 (Double) - Manual (Page 21)

SECTION 3
OPERATION
17
E. Conveyor
The on-off switch for the conveyor motor is on the con-
trol panel. Also on the control panel is the digital con-
veyor speed control. The digital control can be adjusted
from 1-10 min. bake time (conveyor speed).
Refer to Figure 3-3.
Conveyor speed is measured by the amount of time it
takes for an item to go through the bake chamber of the
oven.
MEASURING CONVEYOR SPEED.
See Figures 3-4 and 3-5.
To check conveyor speed, place a product item at the
entrance end of baking chamber as shown. Time how
long it takes for the leading edge of the item to go from
the entrance end of the baking chamber to the exit end.
This should be the conveyor speed shown on the con-
veyor speed digital control.
NOTE: In Figures 3-4 and 3-5, the oven shown is with
the conveyor running right to left.
WARNING
Possibility of injury from rotating parts and
electrical shock exist in this oven.
Never disassemble or clean the oven with the
blower switch or any other part of the oven
turned “ON” or “I”. Turn “OFF” or “O” and lock-
out or tagout all electrical power to the oven
before attempting to clean or service
this oven.
Figure 3-3. Conveyor Speed Digital Control
Figure 3-4. Product at entrance end of baking
chamber – BEGINNING OF TIMING
Figure 3-5. Product at exit end of baking
chamber – END OF TIMING