Mitsubishi Motors 4G1 - Manual (Page 83)

4G1 ENGINE (E - W) - Oil Pump and Oil Pan
11A-10-4
PWEE9520
E
Nov. 1995 Mitsubishi Motors Corporation
"
E
A
OIL FILTER INSTALLATION
(1) Clean the filter mounting surface on the front case.
(2) Apply engine oil to the oil filter’s O-ring.
(3) Screw on the oil filter until the O-ring is seated on the
mounting surface. Then, give the oil filter one further
turn such that it is torqued to approximately 14 Nm.
Caution
The oil filter must be tightened using a commercially
available filter wrench. If the filter is tightened by hand
only, it will be insufficiently torqued, resulting in oil
leaks.