MaxTech XT-7871 - Manual (Page 5)

4
1. Master Power (On rear): Push to provide power to the monitor. This switch
should be left ON for daily operation. Use the front panel On/Off control (3) to
turn the monitor display on and off.
2. Power Saving Indicator: When lit, the monitor is in the DPMS OFF mode.
3. ON/OFF: Press this switch to turn the monitor display on, press again to turn
the monitor display off.
4. Power On Indicator: When lit the monitor is powered on
5. Adjust: Press plus (+) to increase the setting for the selected OSD param-
eter. Press minus (-) to decrease the setting.
6. Select: Press either button to enable the OSD display. Press (
Ш Ш Ш Ш Ш
) to select the
next OSD parameter. Press (
Ч Ч Ч Ч Ч
) to select the previous OSD parameter.
7. Contrast Control: Adjusts the contrast of the display.
8. Brightness Control: Adjusts the display brightness.
2
3
4 8
Figure 3-2 Control and LED Locations
7 6 5