Moen 7025 - Manual (Page 7)

2a. WARNING: Do not straighten bent supply tubes until
step 4.
DECK PLATE MODELS: Install faucet through deck holes
(threaded shank
(16) to back). Center faucet on sink with
support plate (31) oriented in sink holes.
DECK RING MODELS: Place deck ring (20) over supply
tubes (17) and threaded shank (16) against bottom of
faucet body. Install faucet through deck hole (threaded
shank
(16) to back).
FOR ALL MODELS: Position spout to side to keep faucet
from tilting forward. Refer to step 2b for installation of
mounting bracket
(22).
2b. IMPORTANT: DECK THICKNESS (countertop)
Your deck thickness determines whether the mounting
bracket
(22) is installed open side up or down. For spray
models, a groove on the threaded shank (16) indicates the
minimum amount of thread length which must be exposed for proper
attachment of nuts
(23) and (28). For models without spray, a minimum of 1/2"
of threaded shank (16) must be exposed for proper attachment of nut (23).
Position mounting bracket onto threaded shank (16) and around supply tubes
(17). Do NOT kink tubing. Install mounting nut (23) and tighten by hand.
3. Be sure faucet is positioned evenly on sink. Make final tightening of mounting
nut (23) with mounting tool (29).
4. Carefully straighten each supply tube using two
hands. At this time, affix the Caution Hang Tag onto
either supply tube over the 1/2” threaded fitting
(19).
If using flexible supply lines with compression fittings,
thread supply line nuts on finger tight, then holding
one threaded fitting with a wrench, tighten nut with
another wrench, rotating one half turn. Do not
overtighten. Connect the existing hot and cold water
supply lines to the two (2) 1/2” threaded fittings. The
hot supply tube is always to the left when threaded
shank
(16) is positioned to rear.
INS215A HELPLINE: 1-877-DRINK-H2O
1-877-(374-6542)
6
➤
SINK
GROOVE
GROOVE
Back View of
Faucet Installation
SINK
For deck thickness over
1-1/8" deep, install
mounting bracket (22)
OPEN SIDE DOWN.
DECK RING
SINK
For deck thickness up to
1-1/8" deep, install
mounting bracket (22)
OPEN SIDE UP.
➤
GROOVE
CAUTION:
Severe bends of the supply
lines may cause crimping
and restricted water flow
could result.
22
SINK
Deck ring