Moen 7025 - Manual (Page 8)

5. FOR MODELS WITH SPRAY IN DECK PLATE (30),
install spray hose (26) and spray head (24)
through deck plate hole.
6. TO CONNECT SPRAY HOSE FOR ALL SPRAY
MODELS:
Connect spray hose swivel nut (28) to the
threaded shank (16). Tighten swivel nut by hand
plus 1/4 turn with pliers or channel locks being
careful not to twist the spray hose
(26). DO NOT
OVERTIGHTEN.
Flushing is required. See flushing instructions
below.
INS215A 7 HELPLINE: 1-877-DRINK-H2O
1-877-(374-6542)
26
24
LINE FLUSHING INSTRUCTIONS
IMPORTANT: Pipe chips, sand, stones and other solids found in new and
renovated plumbing can damage the sealing surfaces of the filter cartridge and
cause a leak. To avoid damage, DO NOT TURN ON SUPPLY VALVES until
instructed below.
Before you insert the filter and filtering appliance:
1. Turn faucet on in the full cold position (handle
pointing to the right) and allow cold water to flow
for 15 seconds
2. Without turning the faucet off, turn the handle to the full hot position (handle
pointing to the left) and allow hot water to flow for 15 seconds.
3. If side spray is installed, without turning the faucet off, turn the handle to the
mid/mix position (handle pointing toward you) and turn on the spray for 15
seconds.
4. Shut off faucet.
5. You are now ready to insert the filter and filtering appliance.
Sink