Motorola iDEN - Manual (Page 15)

7
Getting Started
Light Sensor
On your i2000 phone, when a key is pressed, the light sensor will activate
the backlight only when your phone is in low light conditions. If
illumination is needed, even when the backlight is not present, you can
manually override the sensor by pressing and holding . This will
activate the backlight. In a charger, the backlight will always be illuminated.
SIM Card PIN
To prevent unauthorized use of your phone, you may set a SIM card PIN.
After the PIN is set, each time the i2000 phone is turned on, a PIN must be
entered. After you set a PIN, you can later change or disable it.
If your i2000 phone requires a SIM PIN, follow the steps in ÒEntering
the PINÓ on page 7.
If your i2000 phone does not require a PIN and you wish to set one,
follow the steps in ÒEnabling the PIN RequirementÓ on page 9.
Entering the PIN
1. Carefully enter your PIN. As you enter it,
an asterisk appears for each character.
This prevents others from seeing your
PIN.
If you enter an incorrect PIN, the
message, ÒWrong PINÓ appears. After
three incorrect attempts, even if you turn
off the phone and turn it on again, the SIM card PIN is blocked. If
this happens, see ÒUnblocking the PINÓ on page 8.
2. Select ÒOKÓ. Now you are ready to place
calls or check your mail.
You can disable the PIN entry requirement.
For more information, see ÒDisabling the PIN
RequirementÓ on page 9.
N O T E As you enter PIN and PUK (pin unblock) numbers,
remember that pressing and holding
dials the
emergency number.
N O T E The Time and Date will not appear on your display
when operating in GSM phone networks.
Enter
****
Cancl OK
SIM PIN
Phone Ready
(System Name)
Name Mail
2:12p 07/21