MGA Entertainment Bratz LR06 - Manual (Page 2)

7 2
2. Take your Bratz™ Movie stars Sharidan™ doll and place her on the Star
Base. Holes in the bottom of her feet will fit on the pegs of the Star Base.
(See Fig. 2).
3. Place the doll about 14+ inches away from the camera.
QUICK START (con‛t)
CAMERA SETUP AND OPERATION
Side & Bottom: The Camera is made up of the following parts (Fig. 3):
a. Shutter Release button
b. “ANIMATE/CAPTURE” Switch
c. “ON/OFF”Switch
d. “DELETE” Button
e. “START/WAKE UP” Button
f. “PLAY” Button
g. Previous Image Button ” “
h. Next Image Button ” “
i. Focus knob
a.
b.
c.
d. e.
h.
g.
f.
Side
i.
Bottom
j.
m.
k. l.
Back
Fig. 2
Back (Fig. 4):
j. Viewfinder
k SD card Slot
l. USB Port
m. Video Out Jack
Fig. 3
Fig. 4
Slow Fast
3. You can use your Movie Stars camera to animate any of your toys! You can even animate pieces of clay
just like the pros!
4. You do not have to use your Digital Camera strictly for animation. You can use it just like a normal camera
to take pictures of people, pets, landscapes or anything else.
• Never insert anything other than an SD card into the camera‛s SD card slot. Doing so may damage both
the camera and the card.
• While the red light on camera is on, press the “START/WAKE UP” button and hold for around 2 seconds
until the red light is off before inserting/removing SD card or connecting/disconnecting the TV video
cable or USB cable, otherwise the camera may be hang or causing data loss stored in built-in memory.
• Make sure that the terminals of the SD card are facing towards the right of the camera.
• Should water or any foreign object ever get into the card slot, immediately turn off the camera and
remove the battery, and then contact your dealer or nearest service provider.
• Use alkaline batteries for best performance and longer life
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix different types of batteries or old and new batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage and damage to the
unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
NOTE: The voltage of a fully-charged, rechargeable battery is often lower than that of a fresh alkaline
battery. Therefore, it is recommended that alkaline batteries be used instead of rechargeable batteries
for best performance and for longest play time.
3
SAFETY INSTRUCTIONS
SAFE BATTERY USAGE
• If the camera “hangs”, reset the camera by the “ON/OFF” switch.
• Turning off the camera by “ON/OFF” switch will cause data loss stored in built-in memory.
• For the best image quality, connect the camera to TV and adjust the focus by watching the TV screen.
• The batteries in the camera are old or improperly installed. Replace old batteries and install them correctly.
• If the camera does not respond, check the cable connection with TV set or computer. Look to see if the
cables are loose or not connected to the proper jack (Refer to the CAMERA SETUP AND OPERATION).
• Computer connections are only for picture storage and individual picture review.
• Capture and Animate function cannot be activated while cable connects to computer.
• The animation or JPG files which are stored in built-in memory of camera cannot be shown or seen while SD
card is inserted into the camera.
NOTE: The camera may malfunction if it is exposed to static electricity. If this happens, reset it by
unplugging and re-plugging the USB Cable into the camera.
SAFE BATTERY USAGE
Illustrations may vary from actual contents.
TROUBLESHOOTING