Madrigal Imaging N380 - Manual (Page 19)

19
setup overview The Nº380 Preamplifier has many provisions for custom-tailoring the system’s op-
eration to match your preferences. The consistent method for modifying any of
these settings is to enter a
setup mode by:
• pressing and holding a button for several seconds;
• the setting is then modified, either by pressing a button or turning
the volume knob;
• and then the new preference is confirmed by pressing and holding
the original button again for several seconds.
This three-step process is simple and logical, yet provides positive feedback that
your change has been accepted and saved for future use. (If you allow the
preamp to “time out” after changing something, your change will still be saved.).
To facilitate operation in complex multisource systems, the Nº380 is capable of
displaying a wide variety of names for each of its six inputs. The available names
are listed below.
available input names
NOT USED (any unused input)
ssp
Surround Sound Processor
EQ Equalizer
DAT Digital Audio Tape
VCR Video Cassette Recorder
CAS Cassette
RTR Reel-To-Reel
DCC Digital Compact Cassette
MD Mini-Disc
CDR Compact Disc, Recordable
CDI Compact Disc, Interactive
SAT Satellite
PH Phono
LD LaserDisc
CD Compact Disc
TUN Tuner
AUX Auxiliary
DAC Digital to Analog Converter
DMX Digital Music Express™ (a cable radio system)
CDP Proceed™ CD Processor
DVD (depends on who you ask…)
DAP Proceed DAP
No30 Mark Levinson Nº30(.5) Digital Audio Processor
No35 Mark Levinson Nº35 Digital Audio Processor
No36 Mark Levinson Nº36(S) Digital Audio Processor
No39 Mark Levinson Nº39 CD Processor
Each name is normally followed by a number corresponding to the number of
the input being used. (The exceptions being the names like “No30” and “No35”
for the corresponding Mark Levinson products.) Thus, a DAT in Input 3 would
normally display a
DAT3 . In this way, you can have more than one CD player, for
example, and still tell at a glance which one is selected.
There is also a special name to indicate that an input is NOT USED .