Operation, Turn on/off procedure, A power on – MITSUBISHI ELECTRIC LVP-XD10U User Manual
Page 11: B standby, External control, A control pad, Ower, Tandby, Ontrol, Apower on
English 7
Operation
Turn On/Off Procedure
A
Power on
Press the Standby/On key for 2 seconds to turn on the lamp. The LED will blink orange
during the warm up and will then light solid green.
z
“INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE” will be displayed on the screen after
the projector has identified the input signal;
z
“SEARCHING” message will be displayed on the screen if there is no signal input;
z
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal frequency of
the input signal exceeds the range of the projector.
B
Standby
Press the Standby/On key for 2 seconds to turn off the lamp. The LED will then blink
green
and the lamp will shut down, but the fan will continue to run for about 1 minute to cool the
lamp. After the fan stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector
will ignore the command until it has cooled down for one minute.
External Control
A Control
Pad
Hotkey
Figure 10 Hotkey control pad
REMOTE
R
ECEIVER
M
ENU
-K
EYSTONE
+K
EYSTONE
A
UTO
L
AMP
S
TATUS
I
NDICATOR
STANDBY
/O
N
I
NDICATOR
S
TANDBY
/O
N
3