MITSUBISHI ELECTRIC LVP-XD10U - Manual (Page 18)

14 English
Figure 18 Lamp replacement: Step 1, Step 2, Step 3
4. Replace the lamp with a new one and fix it using the same
screw.
z Firmly tighten the lamp screw. Loose screws could result
in a poor connection, which could cause the unit to
malfunction.
5. Install the lamp cover and fix it using a screw.
z To prevent burns, install the lamp cover and secure it
using the screw.
z Do not turn on the power with the lamp cover removed.
z Whenever the lamp is replaced, reset the total operation
time of the lamp. Do not reset if the lamp has not been
replaced.
z Do not reset the timer without changing the lamp, as
this can cause the lamp to break.
Press the lamp cover back with a few strength to
make sure the cover fits to the projector without leaks.