MITSUBISHI ELECTRIC LVP-XD10U - Manual (Page 14)

10 English
Inserting Batteries in the Remote Control
Be sure to follow instructions in placing batteries into the remote control units.
z Push and slide the lid in the direction of the arrow.
z Install two ‘AAA’ batteries as indicated inside the battery compartment.
z Replace the lid and snap it into place.
Main Unit Function
Standby/On Turns the projection lamp on and off.
Freeze Pressing this button displays a still (frozen) picture.
Magnify Pressing this button partially magnifies a displayed picture.
(Move the picture with the Disk Pad after pressing the Magnify button.)
Disk Pad When the OSD menu is active, Disk Pad acts as ST selecting device.
When the on-screen menus are not active, it works as mouse pad.
When the magnify function is active, use disk pad to move through the
picture.
Menu To call the OSD Menu.
To enter sub-pages.
To select items.
Blank The blank screen is displayed by pressing Blank. And the blank
screen will be revealed partially from top to bottom by pressing Blank
again.
Source Selects the input source.
Mute Mutes the sound.
Volume Adjusts the volume. The sound gets louder or quieter by pressing the
"+" or "-" button.
Laser Laser-pointer-on button. Use as a stick (for indication).
Mouse Left-Click When operating in the mouse emulation mode, it registers a left
mouse click.
Mouse Right-
Click When operating in the mouse emulation mode, it registers a right
mouse click.
Exit To leave current OSD Pages.
WXDrag To move Left/Right among OSD items.
Caution Caution Caution Caution
z Avoid excessive heat and humidity.
z Do not mix new and old or different types of batteries.