Monster Cable PERFECTVIEW 450L - Manual (Page 18)

14
Installing the PowerMount Mounting System
Remove all pieces of the PowerMount system to ensure
you have all the necessary parts.
Be sure to choose a mounting location with convenient
access to an AC power outlet.
Wood Stud Mounting:
Using an electronic stud sensor, locate two wall studs
up to 15” apart, at your desired mounting location.
�����
�����
With the help of a friend, position the
mounting system’s two horizontal wall plate arms over
the two wall studs. Using the provided level, confi rm
that the mounting system is level.
Mark the stud centers in two slots in the top and
bottom wall plate arms with a pencil.
With your electrical drill and 3/16” (5 mm) bit,
pre-drill a 3” (76.2 mm) deep hole at each mark.
Attach the top wall plate arm to the wall using one
of the supplied lag bolts and washers, as shown
to the right.
Next, place the power unit mounting plate over
the mounting holes on the bottom wall plate arm.
Secure it with the other supplied lag bolt and washer.
Tighten each bolt with your electric drill or socket wrench.
DO NOT over tighten bolts. This can damage
the wall plate or your wall surface.
1)
2)
3)
4)
5)
6)
7)