Metrik Mobile Electronics MCD-476 - Manual (Page 4)

2
Preparation
Please read entire manual before installation.
Before You Start
Disconnect negative battery terminal.(consult a qualified technician for instructions)
Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
Remove 2 transit screws located
on top of the unit.
Insert the supplied keys into the
slots as shown, and slide the unit
out of the mounting sleeve.
Install mounting sleeve into
Opening, bending tabs to secure.
Connect wiring harness and
antenna.(consult a qualified
technician if you are unsure)
Certain vehicles may require an
installation kit and/or wiring
harness adapter(sold separately).
Test for correct operation and slide
into mounting sleeve to secure.
Snap trim ring into place.
HEX BOLT
MOUNTING SLEEVE
MOUNTING STRAP
TAPPING SCREW
SPRING WASHER
PLAIN WASHER
HEX NUT
SECURITY
LED
KEYS
INSTALLATION GUIDE
When is on radio mode, rotate the TUNE button left/right to turn the station.
TUNE
T-UP/DOWN
7
BUTTON FUNCTION
Press EJ to reject a CD from the cartridge, the CD cartridge will automatically close once we
push the cartridge or wait for 10 seconds. Long press EJ force to reject the CD from all modes.
EJECT
Press the OPEN to allow the front panel to detachable panel.
OPEN
Press“ ”go to next song, press“ ”go to previous song.
Long press “ ” fast forward, long press “ ” fast backward.
When no track is playing, press “RDM” to shuffle, the word “RND” will displays on LCD screen
and blinking. Press selects a track. Press STOP cancels the shuffle and stop playing a
track.
When no track is playing, press “PRO” to setup a play list, while “O” is blinking on LCD, press
navigates to the desired track and press “PRO” again to save that track into the play list. Then
the screen back to blinking, keep repeating previous procedure to save the desired track into
the play list. A play list maximum can save 20 tracks. Once a play list reaches the maximum,
the screen displays “ -- ”. Press “STOP” to stop programming play list. Press “PRO” again,
back to the play list, navigates to the desired track; press “MOD” or “PWR” to deletes the track
from the play list. Press “PLAY” to play the play list. While playing a play list, press “REP” to
play a track repeatedly.
RDM
PRO
CD Switch Between Modes
The product has two modes: CD mode and Radio mode. Switch between two modes as follow:
A: Switch from Radio Mode to CD Mode
1)Under Radio Mode insert CD
2)Press MOD, switch to CD Mode
3)Start reading CD, displays total number of tracks in LCD
4)Press PLAY , start to play
B: Switch from CD Mode to Radio Mode
Under CD Mode press MOD to switch to Radio Mode
Remarks: Must Press PLAY to play the track