Metrik Mobile Electronics MCD-476 - Manual (Page 5)

3
Speakers Connection
This unit can mate with 4 as well as 8 speakers .Make sure
Power is off before connecting.
Caution:
Do Not Short speaker wires to chassis ground . It may cause severe
damage.
Ground Connection
Connect Black Wire to Ground terminal. If not found, connect it to
the chassis instead.
Power Connection
First connect the red Wire (w/3Amp fuse ACC) to ignition output.
battery power. Make sure no other device, such as switch, in between.
Then connect orange Wire(w/1 Amp fuse block) directly to +12v
Antenna Connection
Insert coaxial connector to antenna socket.
Caution:
If a fuse is blown , only replace it with one of the sam e rating.
Other wise may cause severe damage . Repeated blown fuse indicates
potential problem(s) exists. A thorough inspection is recommended.
WIRING INSTRUCTION
BAND
REP
PLAY
POWER ON/OFF
When is on radio/CDP mode, turn the VOL button clockwise to increase the volume, turn
anticlockwise to decrease the volume.
VOLUME
MODE
BUTTON FUNCTION
6
Press BAND button to switch between FM/AM.
Press DISP button to display time, long press the DISP button to setup the time.
When the time blinks, press H/M button to set hour/minute; hold H/M to increase H/M
sequentially.
DISP
1) Press DISP to display clock.
Long press DISP to setup the time, while it is blinking, press H/M press to adjust the time.
It will display the time, if you press DISP button again or left it for 5 seconds .
2) Press “H” once to increase one hour, long press to increase sequentially.
3) Press “M” once to increase one minute, long press to increase sequentially.
CLOCK
Press PWR to turn on/off the power.
Press MOD to switch to CD mode. If no CD inside the cartridge, the LCD shows “__”.
When you insert a CD into the cartridge, it reads the CD automatically, and displays
number of tracks on LCD (If a CD is not readable, it displays “E”).
Press PLAY to play first tracks from CD. While it is playing a track, press PLAY to pause/
resume the track, the word “PLAY” will displays on the screen and blinking.
STOP
Press STOP to stop playing a track.
Press REP plays a track repeatedly; long press REP play all tracks repeatedly.