Miele HG02 - Manual (Page 25)

^ Attach the panel to the dishwasher
by lining up the bracket tabs with the
slots on the door.
^ Open the dishwasher door slightly. If
the locking screws on the edge of the
dishwasher door can not be reached,
the dishwasher will have to be pulled
out of its opening a few inches.
^ Push up one side of the door panel
until it touches the filler strips (or con-
trol panel if filler strips are not being
used) and lightly tighten the T20 Torx
screws on the corresponding edge of
the machine door. Do not use a
power screwdriver
^ Repeat the process with the other
side of the door panel.
^ Shut the door.
^ Check that the door panel is adjusted
correctly. It should be snug at the top
and neatly aligned with the adjacent
cabinetry. If it is not aligned properly,
loosen the Torx screws and readjust
the panel
Once the door panel is positioned cor-
rectly:
^ Open the dishwasher door.
^ Tighten all the Torx screws on the
edges of the dishwasher door.
^ Use the provided caps to plug the
locking screw access holes.
Installation
25