Maretron FPM100 - Manual (Page 6)

FPM100 User’s Manual
o 16 programmable tank types including Fuel, Fresh Water, Waste Water
o Programmable tank number(s) up to 16 per tank type
o Programmable tank capacity
1.4 FPM100 Accessories
Maretron offers the following accessories for the FPM100:
• PT-V-0-1BAR-01 Pressure Transducer Vacuum to 1 Bar (14.5 PSI)
• PT-0-3PSI-01
Pressure Transducer 0 to 3 PSI (0.21 bar)
• PT-0-5PSI-01
Pressure Transducer 0 to 5 PSI (0.34 bar)
• PT-0-10PSI-01
Pressure Transducer 0 to 10 PSI (0.69 bar)
• PT-0-50PSI-01
Pressure Transducer 0 to 50 PSI (3.45 bar)
• PT-0-100PSI-01
Pressure Transducer 0 to 100 PSI (6.89 bar)
• PT-0-300PSI-01 Pressure
Transducer 0 to 300 PSI (20.68 bar)
• PT-0-500PSI-01 Pressure Transducer 0 to 500 PSI (34.47 bar)
• PT-0-1000PSI-01 Pressure
Transducer 0 to 1000 PSI (68.95 bar)
• PT-0-3000PSI-01 Pressure
Transducer 0 to 3000 PSI (206.84 bar)
• PT-0-5000PSI-01 Pressure
Transducer 0 to 5000 PSI (344.74 bar)
• PT-SNUB-01
Pressure Snubber
WARNING
Maretron pressure transducers are not approved for use with gasoline. If you
wish to use the FPM100 to monitor pressures or levels of gasoline, you must
obtain a pressure transducer that is approved for use with gasoline.
1.5 Quick Install
Installing the Maretron FPM100 involves the following steps. Please refer to the individual
sections for additional details.
1. Unpack the Box (Section 2.1)
2. Choose a Mounting Location (Section 2.2)
3. Mount the FPM100 (Section 2.3)
4. Connect the FPM100 (Section 2.4)
5. Configure or Program the Mode for each Channel (Section 3.1)
6. For each channel in Pressure/Vacuum mode:
o Set the channel’s instance (Section 3.2.1)
o Set the channel’s source (Section 3.2.5)
o Configure the Pressure at 4mA (Section 3.2.3)
o Configure the Pressure at 20mA (Section 3.2.4)
7. For each channel in Tank mode:
o Configure or Program the Tank Type (Section 3.1)
o Configure or Program the Tank Number (Section 3.3.6)
o Configure or Program Tank Capacity (Section 3.3.4)
Page 2 Revision 1.3