Philips Magnavox CCZ190AT - Manual (Page 10)

10 Automatic Channel Setup
Although the TV/VCR may automatically memorize the channels
you receive when you turn it on for the first time, you may set up
channels again by following the steps below.
1
Press the MENU button.
TO ADJUST PRESS { / B
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION CABLE
2
Press the PLAY/▲ button or the STOP/▼ button to select
INPUT. Press the REW(ind)/SEARCH { button or the
FF/SEARCH B button until ANTENNA or CABLE
(whichever you have) appears beside INPUT.
3
Press the STOP/▼ button repeatedly to select PRIM.
SETUP, then press the FF/SEARCH B button.
PRIMARY SETUP
> SELECT LANGUAGE
AUTO PROGRAMMING
CH MEMORY REVIEW
VOLUME BAR
[ON]
SET CLOCK
SELECT KL CHOOSE B
TO END PRESS EXIT
4
Press the PLAY/▲ button or the STOP/▼ button to select
AUTO PROGRAMMING, then press the FF/SEARCH B
button. AUTO PROGRAMMING MEMORIZED CH ... will
appear on-screen. The TV/VCR will memorize all available chan-
nels.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. You cannot delete it.
• You cannot program channels when
the TV/VCR is on channel 00 (A/V
INPUT will appear beside INPUT at
step 2). Select ANTENNA or CABLE
at step 2.
Helpful Hints
5
Wait for a few minutes. When setup is complete, CHANNELS
ARE SET will appear on-screen. Then the programming of the
lowest channel number placed in the TV/VCR’s memory will
appear on-screen. Now, when you press the CHANNEL o/p
buttons, you will scan only through channels you receive.
5 Wait for the TV/VCR to set up
channels.
POWER CLEAR STATUS/EXIT
1 2 3
4 5 6
7 8 9
0
CHANNEL
SLEEP
MUTE SPEED VOLUME
REW/SEARCH PLAY/ FF/SEARCH
REC/OTR PAUSE/STILL STOP/
+100 ALT.CH
MENU
MEMORY
1
2-4
TO ADJUST PRESS { / B
> INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
CAPTION CABLE
CCZ190comb.QX33 4/5/99 9:51 PM Page 10