Motorola DSR470 - Manual (Page 33)

Installation
DSR470 User Guide 33
4. Go Back.
Press this key to return to a previous menu or the last channel
viewed.
5. Menu. Press this key to display the Menu screen. Press it again to turn off
the Menu and return to CBL mode. Press this key to control the receiver if you
cannot find your remote control.
6. Enter. Press this key to select a highlighted menu option.
7. Arrow Keys. Press these keys to highlight selections from menu screens.
The
L
keys are also used to change the channel or to move up and down on the
menu screen. Use the
!"
keys to move right or left on the menu sceen.
Back Panel Connections
The following back panel descriptions are for reference only. Check with your
dealer and/or system installer for specific details.
1. Power. The power cord is attached here.
2. Cable In. This connects your cable TV service to your system.
3. CH3 CH4. This switch determines the channel (3 or 4) to which you set
your TV to receive broadcasts. The settings should be the same as the TV setting
for use with your VCR (usually channel 3). Your installer should discuss this with
you.
4. Antenna In.
This is an off-air antenna terminal.
5. Out To TV. This supplies the VHF signal to your TV.
6. Audio Out (L & R).
These are audio outputs that may be used to
connect your TV and VCR.
7. To TV.
This is a standard video output terminal.