Connections to audio/video monitor, Connections to audio/video monitor and vcr – Motorola DSR470 User Manual
Page 37
Installation
DSR470 User Guide
37
Connections to Audio/Video Monitor
Complete the following steps if you only plan to connect the receiver to an audio/
video monitor:
•
Using standard RCA-type audio/video cables, connect the top/left TV
(VIDEO output) terminal on the rear panel of the receiver to the video input
terminal on the monitor (or TV using the baseband inputs).
•
Using standard RCA-type audio/video cables, connect the two bottom/left
speaker (R and L) terminals on the back panel of the receiver to the audio input
terminals on the monitor (or TV using the baseband inputs).
Connections to Audio/Video Monitor and VCR
Complete the following steps if you plan to connect the receiver to an audio/video
monitor and VCR:
•
Using standard RCA-type audio/video cables, connect the top/right TV
(VIDEO output) terminal on the rear panel of the receiver to the video input
terminal on the VCR.
•
Using standard RCA-type audio/video cables, connect the two bottom/right
speaker icon (R and L) terminals on the Rear Panel of the receiver to the audio
input terminals on the VCR.
•
Using standard RCA-type audio/video cables, connect the audio and video
inputs on the audio/video monitor (or TV using baseband audio/video inputs)
to the outputs on the VCR.
•
If your entertainment center is enabled for Dolby Digital AC-3 Version 5.1 (six
channel) surround sound, connect this port to one end of the orange RCA cable
and the other end of the orange RCA cable to your surround sound processor.
After you complete the installation procedures, you may wish to use the on-screen
menus to make adjustments to the receiver's operation.