Memorex iTrek Mi3001 - Manual (Page 7)

6
POWER SOURCE
AC CONNECTION
Insert the small end of the AC adapter into the DC IN
jack (located on the rear of the unit). Connect the other
end to a wall outlet having 120V AC, 60 Hz.
NOTES:
• Only use the supplied AC adapter which has the
following specs: DC 9V Z
• Remove both the DC plug and the AC-IN plug to
disconnect the AC adapter when not using.
• The batteries are automatically disconnected when the AC adapter is used.
BATTERY INSTALLATION
To use this unit with battery power, open the
left and right Battery Compartment doors on
the bottom of the unit by sliding them out.
Insert six (6) “AA” size batteries following the
illustration, and close the Battery Compartment
doors.
NOTE:
The AC adapter must be disconnected from the
DC IN jack on the rear of the unit in order for the
unit to operate on battery power.
Left Battery Compartment Right Battery Compartment
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-
zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer’s directions.)
Left Battery Compartment Right Battery Compartment