Miele 06 702 810 - Manual (Page 37)

Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^ Switch the dishwasher off with the
On/Off button s.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
Start/Stop indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twelve
times.
The Delay start indicator light will give
one long flash and two brief flashes at
intervals and "
p 0" or "p 1" will flash in
the display.
The characters flashing in the display
show whether a setting other than the
factory default setting has been set.
– " p 1": All settings are set to factory
default settings.
– " p 0": At least one setting has been
changed.
^ Press the Start/Stop button if you
wish to re-set all the factory default
settings.
^ Switch the dishwasher off with the
On/Off button s.
Operation
37