Moxi 3012 - Manual (Page 40)

Personalize Moxi Cable HD DVR
40
To use the Moxi 3012 to change the widescreen settings, do the fol-
lowing
1. Go to the Widescreen card in the Settings category.
2. Select the desired output setting (for example, cropped, wide mode,
or letter box), and then choose close.
HDTV Setup
The Moxi 3012 automatically adjusts the video output to match the
broadcast format and the selections you make in the HDTV Setup
card.
The video resolution options are 480i, 480p, 720p, and 1080i. Always
use the best resolution allowed by your TV. The following table dis-
plays which resolutions are supported by which cables.
For information on audio cables, see table 4 on page 54.
Setting standard TV video resolution
If your TV is a standard definition (SD) TV, make sure 480i is the only
box checked. All other video resolutions will be output at 480i. You
can still watch HD channels and they may look considerably better
than their SD counterparts.
Table 1: Video connections and supported resolutions
Connection 480i (SD) 480p 720p 1080i
HDMI digital video X X X X
Component video
(YPbPr) X X X X
S-Video X
Composite video (V) X
RF (some models) X
IEEE 1394 (does not
show user interface
graphics) X X X X
If the screen goes blank after you select a video resolution in
error, do not push any buttons, but wait thirty seconds for
video to come back. If it does not, see No video displayed on
page 46 to fix it.
Table 1: Video connections and supported resolutions (Continued)
Connection 480i (SD) 480p 720p 1080i