Miele SALAMANDER GRILL CS 1421 - Manual (Page 18)

Note to the installer:
Please leave this instruction book
with the consumer for the local
electrical inspector’s use.
The minimum distances given in
these Installation Instructions must
be observed in order to ensure safe
operation. Failure to do so increases
the risk of fire.
The cabinetry and venting hood
should be installed first to prevent
damage to the cooktop.
~
The countertop must be bonded
with heat resistant (212 °F/100 °C)
adhesive to prevent distortion or
dissolving.
~
This appliance has not been
designed for maritime use or for use in
mobile installations such as recreational
vehicles or aircraft. However, under
certain conditions it may be possible for
installation in these applications. Please
contact the Miele Technical Service
Department with specific requirements.
~
The appliance should not be
installed immediately beside an electric
barbeque (CS 1312/1322) or the Tepan
Yaki (CS 1326). A minimum distance of
5
7
/
8
" (150 mm) must be maintained
between these units.
~
Ensure that the power cord will not
be subject to mechanical strain after
installation.
~
Also ensure that the power cord will
not come into contact with any hot
spots on the appliance after installation.
Otherwise, the cable could suffer heat
damage.
~
Be sure to comply with the
clearance distances listed below.
~
The appliance must not be
permanently sealed into the countertop
when installed. The sealing strip under
the edge of the appliance provides a
sufficient seal for the countertop. See
"Sealing".
Keep this instruction book in a safe
place for refernce and pass it on to
any further user.
SAFETY INSTRUCTIONS FOR INSTALLATION
18