Miele TOUCHTRONIC G 832 SC - Manual (Page 14)

Water softener
To achieve good cleaning results, the
dishwasher needs soft water. Hard
water results in calcium deposits on
dishware and in the dishwasher.
If your tap water hardness is above
8 gr/gal (values are in US gallons)
(140 ppm), the water should be
softened. This takes place
automatically in the unit’s integrated
water softener.
– Your local water authority will be able
to advise you of the water hardness
level in your area.
– The dishwasher must be
programmed to correspond to the
water hardness in your area.
– The water softener must be filled with
dishwasher salt for reactivation.
Where the water hardness fluctuates
e.g. between 9 - 17 gr/gal (160 - 310
ppm), always program the machine to
the higher value, 17 gr/gal (310 ppm) in
this example.
If there is a fault, it will help the service
technician to know the hardness of your
local water supply.
^ Please note your water hardness:
gr/gal
Turning the water softener off
If your water is consistently soft
(below 8 gr/gal) the salt reservoir
should not be filled with salt and
the water softener can be turned
off completely. The LED will not
light.
The setting cannot be changed during
a running program. Change the setting
at the end of a program or before
starting one.
^ Close the door and turn the
dishwasher on.
The "Start/Stop" indicator flashes.
^ Press and hold the "Start/Stop" button
while turning the dishwasher on.
^ Release the "Start/Stop" button and
immediately press it two more times.
The "Intake/Drain" and "Salt" indicators
flash. If they are not flashing, start over.
^ Press the "Top Solo" button twice.
The "Intake/Drain" and "Salt" indicators
flash and the "End" indicator lights.
^ Use the arrow buttons to select "Sani
Wash".
^ Use the "Top Solo" button to change
the status of the water softener.
Sani Wash LED flashes =
Water softener ON
Sani Wash LED lights =
Water softener OFF
Before using for the first time
14