Miele TOUCHTRONIC G 832 SC - Manual (Page 15)

Programming the water softener
If your water is over 8 gr/gal the salt
reservoir must be filled with salt. Your
water hardness level must be
programmed into the dishwasher using
the buttons on the control panel.
^ Make sure the dishwasher is turned
off.
^ Press and hold the "Start/Stop" button
(17) and at the same time turn on the
dishwasher with the "On/Off" button
(13). Release the "Start/Stop" button
within two seconds.
The "Rinse" (16) indicator and the
Pots & Pans indicator (14) will light and
the "Salt" (15) indicator will flash.
If this is not the case, the above steps
must be repeated.
1 - 24 gr/gal:
^ Use the program selection buttons
(19) to select the program which
corresponds to the local water
hardness.
Table 1:
gr/gal* ppm Program indicator
1 - 4** 20 - 70 Pots & Pans
5 - 7 90 - 130 Sani Wash
8 - 11 140 - 200 Normal Plus
12 - 16 220 - 280 Normal
17 - 21 300 - 370 China & Crystal
22 - 24 390 - 430 Rinse and Hold
* US gallons
** factory preset
The selected program indicator (14) will
flash and the "Rinse" (16) indicator will
light.
^ To store this setting press the
"Start/Stop" (17) button twice.
^ Turn off the dishwasher with the
"On/Off" button (13).
Before using for the first time
15