Moxa Technologies 6450 - Manual (Page 28)

4-8 www.moxa.com e-mail: [email protected]
S
e
cu
re
T
e
rm
in
a
l S
e
rv
e
rs
/T
e
rm
in
a
l S
e
rv
e
rs
Secure Terminal Server/Terminal Server
Primary PC, LAN B,
and 1st CN10 dead
The CN2610 uses 4 IP addresses in a DRDAS system. In the figure on
the previous page, RTU data is received through a serial port on the
CN2610, and the data is transmitted to two PCs on two different LANs
using a total of four IP addresses. One of the four IP addresses is the
primary IP for transmitting data downstream to the RTU. The other
three IP addresses may not transmit data to the RTU as long as the
primary IP continues to be operational. This kind of architecture allows
the system to continue operation even if the Primary PC, LAN B, and
the Primary CN2610 crash at the same time.
19-inch Rackmount
The Rackmount Kit is a Standard Accessory
Serial Ports
8-pin RJ45, RS-232, 50 to 921.6 Kbps
AC Power Input
100 to 240 VAC Input, 47 to 63 Hz
LCM Display Panel
Reset Button
Push Buttons
LED Indicators
System Status, Serial Tx/Rx
Ethernet
RJ45 10/100 Mbps
Connection Cable
8-pin RJ45 to DB9 Cable
RS- Console Port
CN2610 Series Appearance
CN10-8: 8-port RS-232 Dual LAN Async Server
CN10-8-48V: 8-port RS-232 Dual LAN Async Server Package Checklist
• 1 CN2610
• Quick Installation Guide
• Document and Software CD-ROM
• Power Cord x 1 (AC model only)
• CBL-RJ45F9-150 x 1
• CBL-RJ45M25-150 x 1
Optional Accessories
Power Cord: See page 12-10
Serial Cable & Serial Adapter: See page 12-4
Ordering Information
4
Data Acquisition Redundancy
IP Systèmes, importateur/distributeur des solutions de communication industrielle MOXA en France Tel : 0820 200 290 (15cts/min)