M-AUDIO Digital DJ System - Manual (Page 20)

Torq MixLab User Guide » Chapter 1
19
Torq MixLab User Guide » Chapter 3
19
Offset Buttons
Sometimes when mixing two songs together, you may find that the beats are aligned with each other, yet the two songs
are still out of phase. This is most obvious when one song is offset by one beat, causing the snare drums of the tracks
to be out of alignment. The Offset buttons can be used to correct this. Pressing these buttons will make the Current
Song Position jump forward or back by one beat-length.
Note: If you have the Sync Mode set to “Bar” in the Preferences, the Offset buttons will have no effect when the
Deck’s Sync button is on. This is because Torq LE will counteract a one-beat offset when set to Bar mode. If you want
to offset the music by one beat when Sync is on, you’ll need to offset the Phase Grid, which is explained later in the
section titled “Synchronization.”