Master Lock BR150CE - Manual (Page 15)

15
102384
Fan
IMPORTANT: Remove fan
from motor shaft before
removing motor from heater.
The weight of the motor
resting on the fan could
damage the fan pitch.
1. Remove upper shell (see
page 10).
2. Use 1/8" allen wrench to
loosen setscrew which
holds fan to motor shaft.
3. Slip fan off motor shaft.
4. Clean fan using a soft cloth
moistened with kerosene or
solvent.
5. Dry fan thoroughly.
6. Replace fan on motor
shaft. Place fan hub flush
with end of motor shaft
(see Figure 19).
7. Place setscrew on flat of
shaft. Tighten setscrew
firmly (40-50 inch-pounds/
4.5-5.6 n-m).
8. Replace fan guard and
upper shell.
Motor
Shaft
Setscrew
Figure 18 - Fan, Motor Shaft, and Setscrew Location
Motor
Shaft
Fan
Setscrew
Figure 19 - Fan Cross Section
Output Rating (Btu/Hr) 150,000
Fuel Use Only Kerosene or No. 1 Fuel Oil
Fuel Tank Capacity
(U.S. Gal./Liters) 13.5/51.1
Fuel Consumption
(Gal. Per Hr./Liters Per Hr.) 1.1/4.1
Electric Requirements 220 V/50 Hz
Amperage (Normal Run) 1.2
Hot Air Output (CFM/CMM) 500/14.2
RPM 2850
SPECIFICATIONS
Fan
Flush