MITSUBISHI ELECTRIC WS-55711 - Manual (Page 13)

12 13
Back Panel
�
Inputs 1-4
These inputs can be used for the connection of a VCR, Super VHS (S-VHS) VCR, DVD player, standard
satellite receiver or other A/V device to the TV. Please note that if you connect to the S-VIDEO terminal,
the VIDEO terminal is deactivated. The VIDEO terminal is active when there is no S-Video connection.
�
Output (Monitor and PIP)
The Monitor Output sends the TV audio and video signals from Ant-A, Ant-B and Inputs 1-5 to an A/V
Receiver or other analog A/V equipment. Monitor Output will also provide the signals, converted to analog
signals, received from Ant-DTV and IEEE-1394 products. There will be no video signals from digital
products if the original signals are copy protected.
From VGA, Component 1 and 2 and Input-DTV, no signals will be sent. The PIP output sends the PIP’s or
POP’s audio signal to an amplifier or wireless headphones. If no PIP or POP is displayed, the PIP output
will not send any audio.
� Antenna (ANT-A, LOOP OUT, and ANT-B)
ANT-A and ANT-B receive analog NTSC signals from VHF/UHF antennas or an analog NTSC cable
system. LOOP OUT sends the ANT-A signal out to another component, such as a cable box or VCR.
4
IR Emitter-Repeater
Connecting IR emitters here allows the TV to pass IR commands from most IR remote controls to other A/V
devices that are out of range of the remote control.
5
VGA
This input can be used for the connection of a computer. Please see Appendix B for signal compatibility.
6
Component Inputs 1-2
These inputs can be used for the connection of A/V equipment with component video outputs, such as a
DVD player. Please see Appendix B for signal compatibility.
7 DTV Input
This input is used to connect an external DTV receiver, and can be configured for HDTV signal types
component (YPrPb), RGB sync on green, and RGB plus H&V. Please see Appendix B for signal
compatibility.