Monster Cable PERFECTVIEW 450M - Manual (Page 34)

30
Routing Your TV’s Power Cord and AV Cable
through the Cable Management System
Routing and Connecting Your TV’s Power Cord
Once your mount and TV are completely installed,
fully extend the mount’s swing arms from the wall
and swivel your TV left or right.
Connect your TV’s power cord to the TV
(if TV uses detachable-type power cord).
Remove the end cap from the Power Mount’s bottom
swing arm. Next, slide off the bottom arm’s cable
management cover.
Route the TV power cord through the arm, as shown.
Once completed, reattach the cable management
cover and end cap.
Plug the TV power cord into one of the power unit’s
AC outlets.
Plug the PowerMount’s attached 8ft. power cord into
a nearby AC wall outlet.
LED indicators on the PowerMount should illuminate.
“Clean Power ON” indicates Clean Power
™
Clean Power Clean Power fi ltering
is active.
“Ground OK” indicates house wiring and/or AC outlet
is properly grounded. If not illuminated, unplug
PowerMount and consult an electrician.
1)
2)
3)
4)
5)
6)
7)
8)
9)